Recommended test
Increase two rectangular openings' headers and inspect the fitted studs before applying.
- Right-click a load-bearing header and choose Update opening headers. Confirm only its opening is checked; then select another row or use Select unedited.
- Increase Header height, enable Fit studs to headers and preview. Check each opening's dimensions, wall and storey.
- Set thickness to the stud depth and confirm the full-depth beam leaves clean shorter supports below it.
- Apply updates, Undo the batch, then repeat and save/reopen the project.
Set the generator’s header section
In Build > Building > Walls > Advanced, find Load-bearing headers below the stud dimensions. Set height and thickness; the default is 148 × 48 mm. Thickness cannot exceed wall stud depth. These settings apply to rectangular main-wall openings on both storeys when generated and save with the design. They define geometry, not a structural load calculation.
Update existing openings
Right-click an ordinary or load-bearing header and choose Update opening headers. Select the header type, first storey, second storey or both, then check the openings to include. The list belongs to the same building. Each row shows opening width and height, wall number, storey and the existing/proposed header section.
Only the opening whose header you clicked starts checked. Other openings start unchecked. Use Select unedited to include all supported untouched headers in the selected type/storeys, or check individual rows. Changing the header type or storeys never automatically checks more openings; checked rows outside the new scope are cleared. Clear selection unchecks everything.
Edited headers require deliberate selection; the clicked header still starts selected if it was edited. Hidden checked openings are included. Triangular, tapered, sloping and unsupported openings are excluded.
Enter Header height and Header thickness in millimetres. Each header keeps its own length. Load-bearing headers keep their top edge and flush wall face; ordinary headers keep the opening’s clear height and centre the thickness change. This updates the selected model parts, not the generator defaults.
Headers from automatic ridge-support sizing
Headers generated by Automatic roof dimensions also support this tool. Their automatic origin is shown with a warning: manually changing the header invalidates the preliminary support calculation based on the project’s inputs.
Calculated headers preserve opening clear height and stay centred in the wall. A deeper header can fit the upper post; shrinking it can leave a gap. Inspect the whole support path, not just the opening. Manual edits survive saving and reopening. Reset the customization before automatic recalculation, or disable automatic roof sizing to continue Manual modelling.
Fit studs to a deeper or thicker beam
Enable Fit studs to headers to cut additional overlap from each opening’s own studs using its resized header. Existing notches and edits are retained. A beam as thick as the studs removes the whole notch depth, leaving clean shorter supports beneath it rather than a thin face across the beam.
Preview updates shows headers in blue and fitted studs in green. Resolve invalid cuts or exclude the affected opening before applying. Apply updates commits one undoable batch; Cancel leaves the model unchanged. Names, groups and materials remain, and changed parts become independent with an Edited badge.
Shrinking a beam does not fill old cuts. Reset customization or regenerate to restore stock. Later header changes do not automatically refit studs: run the tool again and explicitly include the edited headers. Save/reopen retains exact results; compatible regeneration follows the edited-object review workflow.